Thursday, November 21, 2019

Tutorial Thursday - Layered Christmas Card

Hi it's Jennifer here with a layered Shaker Card Tutorial.


The Products used 



To Create the frame I cut a piece of white cardstock 4 7/8 x 4 7/8
and then used the 2nd largest Bracket Die on all 4 edges and then
used the largest Double Stitched Square to cut out the centre.



Backing Blue Paper and Acetate to be cut at 4 2/8 x 4 2/8

Then I created two frames for layering on  cut 2 at 4 2/8 x 4 2/8
then cut the centre out with the Double Stitched Square.

Using the Blue Backing Paper I decorated it with the trees and houses.
Some of the Trees are 3D'd.

Using one of the frames I then added a snow slope using the
 Double Stitched Hills Die and some extra White Card Stock.
I then added a 3D'd Horse and Sleigh. I also ran 3D tape around the 
back of the frame.

Run 3D tape around the back of this frame too.

The Acetate gets taped to the back of this frame. Also run 3D
 tape around the back of it too.

So now to layer them all up. I started with the Blue backing Paper.
I then layered the Horse and Sleigh Layer. Next layer was just the plain
 frame to give it height. Then I added a few sequins to shake around 
in it. I then placed the Acetate front to seal in the sequins.

I then created a base with White Card Stock 10 6/8 x 5 5/16
I layered it with the pretty Blue Bauble Paper 5 3/16 x 5 3/16

Then tape Frame to the base and finish decorating.



1 comment: